Care And Cleaning Instructions - Unify OpenScape Desk Phone CP400T Installations- Und Kurzanleitung

Important Notes
For safety reasons, the telephone can only be supplied with power as follows:
7
• with the supplied original power supply unit of the OpenScape system.
Never open the telephone. If you encounter any problems, contact your
7
technical support.
Use only original accessories! Using other accessories may be dangerous,
7
and will invalidate the warranty, extended manufacturer's liability and the
CE mark and other certifications.
Note (for USA only)
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause un-
desired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communications. However, there is no guaran-
tee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications made to this equipment not expressly approved by the party respon-
sible for compliance may void the FCC authorization to operate this equipment.
This product is certified by a Nationally Recognized Testing Laboratory (NRTL). This equipment
also complies with Part 68 of the FCC Rules.
Note (for Canada only)
This device complies with Industry Canada's licence-exempt RSSs. Operation is subject to the
following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
CAN ICES-3 (B)/NMB-3(B)
This product is certified by a Nationally Recognized Testing Laboratory (NRTL). This equipment
also complies with Industry Canada CS-03.
Marks
The compliance of the equipment according to EU directives is confirmed
by the CE mark. This Declaration of Conformity and, where applicable, oth-
er existing declarations of conformity as well as further information on reg-
ulations that restrict the usage of substances or affect the declaration of sub-
stances used in products can be found in the Unify Expert WIKI at
http://wiki.unify.com
All electrical and electronic products should be disposed of separately from
the municipal waste stream via designated collection facilities appointed by
the government or the local authorities. The correct disposal and separate
collection of your old appliance will help prevent potential negative conse-
quences for the environment and human health. It is a precondition for re-
use and recycling of used electrical and electronic equipment. For more de-
tailed information about disposal of your old appliance, please contact your
city office, waste disposal service, the shop where you purchased the prod-
uct or your sales representative. The statements quoted above are only fully
valid for equipment which is installed and sold in the countries of the Euro-
pean Union and is covered by the directive 2012/19/EU. Countries outside
the European Union may have other regulations regarding the disposal of
electrical and electronic equipment.

Care and cleaning instructions

• Never spray liquids onto the telephone since any liquid penetrating the tele-
phone can lead to malfunctions or destruction of the device.
• Any substances such as alcohol, chemicals, solvents or scouring agents should
also be avoided since these may damage the surface.
• Clean the telephone with a soft cloth moistened with water.
under the section "Declarations of Conformity".
7