Preparation Before Operation; I Indoor Unit; I Remote Control; How To Operate - Panasonic CS-C7CKP Bedienungsanleitung

PREPARATION BEFORE OPERATION

I Indoor Unit

6
3
5
4
1
Connect the power supply cord to an independent
power supply
2
Open the front panel
3
Remove the air filters
AUTO HEAT COOL DRY FAN
AUTO
4
Fit the air purifying filters in place
5
Insert the air filters
AUTO
FAN
6
Close the front panel

I Remote Control

– To set the current time
AIR SWING
AUTO MANUAL FAN SPEED
1 2
ON
OFF
CANCEL
TIMER
CHECK RESET CLOCK
1 Press 1.
2
Then press 2 to increase or decrease the time.
3
Press 1 again.
Set time at display will light up.
5

HOW TO OPERATE

1
2
I To start the operation
• Press 1.
• POWER indicator (green) on the indoor unit will light
up.
• To stop, press once more.
I Setting Mode
• Press 2 to select:-
3
SET
2
1
2
3
5
1
6
4
Cooling Model
AUTO – Automatic Operation
COOL – Cooling Operation
DRY – Soft Dry Operation
FAN – Air Circulation Operation
Heat Pump Model
AUTO – Automatic Operation
HEAT – Heating Operation
COOL – Cooling Operation
DRY – Soft Dry Operation
I Setting Temperature
• Press 3 to increase or decrease the temperature.
• The temperature can be set between 16°C ~ 30°C.
• Recommended temperature:
Cooling Model Heat Pump Model
COOL –> 26°C ~ 28°C
COOL –> 26°C ~ 28°C
DRY –> 1°C ~ 2°C
DRY –> 1°C ~ 2°C
lower than the
lower than the
room temperature
room temperature
HEAT –> 20°C ~ 24°C
• During AUTO Operation, press 3 to select:-
• Operation with 2°C higher than the standard
temperature.
• Operation with the standard temperature.
• Operation with 2°C lower than the standard
temperature.
G Standard Temperature
Cooling Model
Indoor
Operation
temperature
Cooling
23°C
Soft Dry
• Once the Automatic Operation is selected, the indoor
temperature sensor operates automatically to select
the desired operation mode with Cooling or Soft Dry.
• After the operation mode has been selected, the
mode does not change.
Heat Pump Model
Indoor
Operation
temperature
Cooling
23°C Soft Dry
20°C
Heating
• At the beginning of the automatic operation, Heating,
Cooling or Soft Dry is automatically selected according
to the indoor temperature.
• The operation mode changes every hour, when
necessary.
Standard
temperature
25°C
22°C
Standard
temperature
25°C
22°C
21°C