Cutting Height Adjustment; Changing The Pin Code; Emergency Stop - Yard Force Classic 500B Installationsanleitung

GB
for example:
if now is 08:25, please press
if now is 09:45, please press
if now is 14:25, please press
if now is 16:45, please press
Three seconds later, all these LED will flash off
Congratulations, all calibration have been completed, The mower will restart, now you can enjoy
the scheduled mowing in your garden.
Start mowing
After finishing the time settings, now you can start your Robotic Mower
1. Press the button for 4 times to unlock the panel.
2. Press the button and then press the button
Return to the docking station
1. Press the button for 4 times to unlock the panel.
2. Press the button and then press the button
docking station.

Emergency Stop

Press STOP button to halt the mower at any time.
, and then you would hear a beep.
, and then you would hear a beep.
, and then you would hear a beep.
, and then you would hear a beep.
, the Robotic Mower will start to work.
, the Robotic Mower will back to the
12

Cutting height adjustment

The cutting height can be adjusted by rotating the height adjustment dial located on the top
of the machine. Cutting height range from 20 mm - 60 mm.
NOTE!
We recommend using an ordinary lawn mower or trimmer to cut the lawn below 60 mm
before using the Robotic Mower. This will ensure you get the optimum performance.

Changing the PIN Code

1. Switch Off the mains power switch.
2. Hold down the lock button while switch ON the main power switch. After few
seconds, all indicators on the control panel will start flashing.
3. Release the lock button .
4. Enter you new PIN-Code within 6 seconds, the Robotic Mower will confirm and changed
PIN with a beep.
5. All indicators will turn off and the Robotic Mower will reboot, and the indicator of lock
button will flash, confirming that the reboot is complete.
NOTE: if you do not remember your PIN code, please set a new PIN code as described
above, but it is not possible to reset the device to the default PIN-code of 4X .