Concept MM4300 Bedienungsanleitung Seite 30

EN
MEAT BALL PREPARATION
Assembly of the adapter for the preparation of meat balls
1. Put the auger with a plastic end forwards into the grinder body.
2. Attach the extruder disc and the cap for preparation of meat balls onto
the auger axis.
3. Make sure that the securing groove on the extruder disk engages in the
pin on the grinder body.
4. Tighten the grinder nut.
5. Attach the assembled grinder body to the motor unit. Push the grinder
body at a 45° angle to the motor unit and turn the grinder body counter
clockwise until you hear a click. Check if the adapter is properly fastened
and cannot be released and removed without using the lock button.
6. Check the tightening of the grinder nut.
7. Place the hopper on the grinder mouth.
8. Now the appliance is ready for use.
Note: This accessory is used without replaceable discs and without a cross-
blade knife. Prepare a meat mixture, that should be well minced, flavoured
and mixed.
Put the mixture gradually into the inlet of the appliance.
Do not push too hard, otherwise the appliance may get clogged.
9. Shape the extruded mixture to your liking.
10. When you are done with processing, you can push out any residues
from the adapter by inserting and processing a few pieces of bread.
11. After processing, switch off the appliance by pressing the on/off button
and disconnect it from the electrical outlet.
12. To release the adapter from the holder, keep pressing the lock button
and simultaneously rotate the adapter clockwise to release it.
13. Loosen the grinder nut to disassemble the adapter.
58
PURÉE PREPARATION
Assembly of the adapter for the preparation of purée.
1. Put the auger with a plastic end forwards into the grinder body.
2. Attach the screen onto the auger axis.
3. Make sure that the tabs of the screen fit into the cut-outs on the grinder
body.
4. Secure the grinder nut and screw on the nut cap.
5. Attach the assembled grinder body to the motor unit. Push the grinder
body at a 45° angle to the motor unit and turn the grinder body counter
clockwise until you hear a click. Check if the adapter is properly fastened
and cannot be released and removed without using the lock button.
6. Check the tightening of the grinder nut.
7. Place the hopper on the grinder mouth.
8. Place a bowl for the processed purée under the grinder body.
9. Frozen food must be thawed prior to processing. Cut the ingredients to
slices of approximately 2 x 2 cm.
10. Press the on/off button to turn on the appliance.
11. After processing, switch off the appliance by pressing the on/off button
and disconnect it from the electrical outlet.
12. To release the adapter from the holder, keep pressing the lock button
and simultaneously rotate the adapter clockwise to release it.
This appliance is equipped with a protection system against over-current. This system automatically breaks the circuit
in case of excessive current to protect the appliance.
If your device suddenly stops:
1. Disconnect the power cord from the socket.
2. Allow the unit to cool down for 60 minutes.
3. Reconnect the power cord.
4. Press the on/off switch to turn off the appliance.
5. Turn on the appliance by pressing the over-current protection button (H) at the bottom of the appliance.
6. Turn on the appliance.
Contact an authorized service centre if the over-current protection gets activated too frequently.
NOTICE: To avoid a hazardous situation, do not connect this appliance to the timer switch.
MM4300 MM4300
EN
59