Technical Data - Meec tools 082-211 Gebrauchsanleitung

IMPORTANT: The product must only be used by persons who have had proper training. Check that the
product has not been damaged during transportation. Only use clean, dry air.
Connect the air hose to the air coupling.
•
The paint container or paint hose must be connected firmly to the paint connection.
•
Rinse the spray gun's paint ducts using an appropriate solvent.
•
• Pour paint into the paint container, test spray and adjust the outgoing paint flow and pattern width.
Max. Operating pressure
Noise level
Temperature
Feeding
Volume
Operating pressure
Air flow
Air cap, diameter
Paint nozzle, diameter:
Fan diameter
Paint flow
Sound pressure level, LpA
Sound power level, LwA
Vibration level
Always use hearing protection!
Appropriate air pressure is 2–3 bar.
• The recommended paint viscosity varies depending on the
paint's characteristics and surrounding conditions when
spraying (18 ± 2 s recommended).
Use the lowest possible outgoing flow. It gives better surface
•
results with atomisation.
The distance between the spray gun and the workpiece should
•
be as small as possible (150–200 mm).
Always hold the spray gun perpendicular to the workpiece
•
surface.
Move the spray gun in straight lines horizontally.
•
If you move the spray gun in turns, the paint coat will be
•
uneven.
WARNING:
Turn off the air and fluid flow to the spray gun and relieve the pressure by pressing the trigger before
•
disassembly, cleaning and/or service.
The spray gun contains sharp parts – risk of cut injuries.
•
The product must only be dismantled by persons who have had proper training.
•
1. Pour remaining paint into another container and clean the paint ducts and air cap. Spray a small
amount of solvent to clean the paint ducts. Inadequate cleaning can cause incorrect patterns and/or
particles in the paint. Thoroughly clean the spray gun immediately after using two-component paint.
2. Clean the other parts with solvent and the included brush and a cloth.
3. Clean the paint ducts fully before dismantling the spray gun.
4. Remove the paint needle before removing the paint nozzle, or hold the needle retracted, otherwise
the seat may be damaged.
5. Insert the paint needle and screw on the paint needle seal by hand. Tighten carefully with a spanner.
Adjust the seal while you press in the trigger and check how the paint needle moves. Do not over-
tighten, as the paint needle moves slower, which will result in leakage from the nozzle tip.
6. If this is the case, loosen anti-clockwise until the needle moves freely without paint leakage.
7. Turn the pattern knob anti-clockwise to the fully open position and screw in the pattern guide in the
body.
ENGLISH

TECHNICAL DATA

6 bar
74.8 dB(A)
5–40°C
Gravity
100 ml
1.5 bar
70 l/min
4.2 mm
0.8 mm
80-130 mm
30-80 ml/min
67 dB(A), K= 3 dB
78 dB(A), K= 3 dB
<2,5 m/s2, K= 1,5 m/s²
OPERATION
MAINTENANCE
14
1.0 mm
80-130 mm
30-80 ml/min