Atag DW7113XA Gebrauchsanweisung Seite 163

Table continued from last page
Problem
Water remains in the
dishwasher.
Bad odour in dishwasher.
Grease deposits in the
dishwasher.
The dishes are not dry enough.
Possible causes
The filters are blocked.
The filters are not fitted correctly.
Debris in the drainage pump.
Drainage pump stop missing.
Kink in drainage hose.
Blocked drainage hose.
Dirt around the seals and in
corners.
Low temperature programs have
been selected for a prolonged
period.
Low temperature programs have
been selected for a prolonged
period.
The Auto Open option is not
activated.
The dishwasher is not fully
loaded.
Rinse aid needs topping up or
dosage is set too low.
The setting TAB is activated and
all-in-one detergent with
insufficient drying effect is being
used.
Troubleshooting
Action
Clean the coarse and fine filters.
Check that the filter handle is
locked in the stop position.
Clean the drainage pump. See
the chapter Care and cleaning.
Check that the coloured stop on
the right in the bottom drain is in
place. See the chapter Care and
cleaning.
Check that the hose is free from
kinks and sharp bends.
Disconnect the drainage hose
where it connects to the sink
unit's water trap. Check that no
debris has fastened and that the
connection has an inner
diameter of at least 14 mm.
Clean with washing-up brush
and low foaming cleaner.
Run a program with a high
temperature once or twice a
month.
Select a program with a high
temperature to dissolve grease
on very dirty dishes, such as
Intensive.
Activate the Auto Open option.
Fully load the dishwasher.
Top up with rinse aid or increase
the rinse aid dosage level. See
the chapter Settings.
Switch all-in-one detergents or
deactivate the setting TAB and
top up with salt and separate
rinse aid. See Rinse aid in the
chapter Settings.
33