Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

3. Make sure that the salt container and the rinse aid
dispenser are full.
4. Start the shortest programme with a rinsing phase,
without detergent and without dishes.
5. Adjust the water softener to the water hardness in
your area.
6. Adjust the released quantity of rinse aid.
Setting and starting a programme
Setting mode
The appliance must be in setting mode to accept some
operations.
The appliance is in setting mode when, after the activa-
tion:
• All the programme indicators are off.
• The end indicator flashes.
If the control panel shows other conditions, press and
hold the programme button until the appliance is in set-
ting mode.
Starting a programme without delay start
1. Open the water tap.
2. Press the on/off button to activate the appliance.
Make sure that the appliance is in setting mode.
3. Press continuously the programme button until the
indicator of the programme you want to set comes on.
4. Close the appliance door. The programme starts.
Starting a programme with delay start
1. Set the programme.
2. Press the delay button to delay the start of the pro-
gramme of 3 hours. The delay indicator comes on.
3. Close the appliance door. The countdown starts.
• When the countdown is completed, the pro-
gramme starts.
Opening the door while the appliance operates
If you open the door, the appliance stops. When you close
the door, the appliance continues from the point of inter-
ruption.

Care and cleaning

Warning! Before maintenance, deactivate the
appliance and disconnect the mains plug from the
mains socket.
22
Cancelling the delay start while the countdown operates
1. Open the appliance door.
2. Press the delay button, the delay indicator goes off.
3. Close the appliance door. The programme starts.
Cancelling the programme
1. Open the appliance door.
2. Press and hold the programme button until the indi-
cator of the set programme goes off and the end indi-
cator flashes.
Make sure that there is detergent in the detergent
dispenser before you start a new programme.
At the end of the programme
When the programme is completed, an intermittent acous-
tic signal operates.
1. Open the appliance door.
• The end indicator is on.
2. Press the on/off button to deactivate the appliance.
3. Close the water tap.
• For better drying results, keep the appliance door ajar
for some minutes.
• Let the dishes become cold before you remove them
from the appliance. Hot dishes can be easily damaged.
• First remove the items from the lower basket, then from
the upper basket.
There can be water on the sides and on the door of
the appliance. Stainless steel becomes cool more
quickly than the dishes.
Dirty filters and clogged spray arms decrease the
washing results.
Make a check regularly and, if necessary, clean them.

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis