Accessories; Technical Data - Gardena EasyCut 420/45 Betriebsanleitung

3. MAINTENANCE
DANGER! Risk of injury!
Cut injury when the product starts accidentally.
v Before you maintain the product, make sure that the mains
cable is disconnected and the protective cover
the blade 2 .
To clean the hedge trimmer [ Fig. M1 ]:
DANGER! Electric shock!
Risk of injury and risk of damage to property.
v Do not clean the product with water or with a water jet
(in particular high-pressure water jet).
1. Clean the product with a damp cloth.
2. Clean the airflow slots with a soft brush (do not use a screwdriver).
2
3. Lubricate the blade with a low viscosity oil (e. g. GARDENA spray-oil
Art. 2366). Avoid contact with the plastic parts.
4. STORAGE
To put into storage [ Fig. S1 ]:
The product must be stored away from children.
1. Disconnect the mains cable.
2. Clean the product (see 3. MAINTENANCE) and slide the protective
cover 1 over the blade 2 .
3. Stowe the product in a dry area where it has protection from frost.
Disposal:
(in accordance with RL2012/19/EC)
The product must not be disposed of to normal household waste.
It must be disposed of in line with local environmental regulations.
IMPORTANT!
v Dispose of the product through or via your municipal recycling
c ollection centre.
5. TROUBLESHOOTING
DANGER! Risk of injury!
Cut injury when the product starts accidentally.
v Before you troubleshoot the product, make sure that the mains
cable is disconnected and the protective cover
the blade 2 .
Problem Possible Cause
Product does not start Extension cable not connected
or damaged.
Blade blocked.
Product can no longer be Start button is stuck.
stopped
Hedge is not cleanly cut Blade blunt or damaged.
NOTE: For any other malfunctions please contact the GARDENA service depart-
ment. Repairs must only be done by GARDENA service departments or specialist
dealers approved by GARDENA.

6. TECHNICAL DATA

Electric Hedge Trimmer Unit Value
EasyCut 420/45
(Art. 9830)
Motor power consumption W 420
Mains voltage /
V / Hz 230 / 50
Mains frequency
Strokes /min. 3,800
Length of blade cm 45
Tooth gap of blade mm 18
Weight kg 2.7
(approx.)
Electric Hedge Trimmer
Sound pressure level L
Uncertainty k
Sound power level L
measured / guaranteed
1 is slid over
Uncertainty k
Hand/arm vibration a
Uncertainty k
Measuring process complying with:

7. ACCESSORIES

GARDENA Maintenance Oil
GARDENA Collecting Bag
Cut&Collect EasyCut
8. SERVICE / WARRANTY
Service:
Please contact the address on the back page.
Warranty:
In the event of a warranty claim, no charge is levied to you for the services
provided.
GARDENA Manufacturing GmbH offers a 2-year warranty for this product
(from the date of purchase) if the product has been used exclusively for
private purposes. This manufacturer's warranty does not apply to used
products purchased from a secondary market. This warranty includes all
significant defects of the product that can be proved to be material or
manufacturing faults. This war ranty is fulfilled by supplying a fully functional
replacement product or by repairing the faulty product sent to us free of
charge; we reserve the right to choose between these options. This ser-
vice is subject to the following provisions:
• The product was used for its intended purpose as per the recom-
• Neither the purchaser nor a third party has attempted to repair the
• Only original GARDENA spare and wear parts were used.
Normal wear and tear of parts and components, optical changes, as well
1 is slid over as wear parts and consumables, are excluded from the warranty.
This manufacturer's warranty does not affect warranty entitlements against
the dealer / retailer.
Remedy
v Connect the extension cable
or if necessary replace it.
v Remove obstacle.
v Disconnect the mains cable
and loosen start buttons.
Consumables:
v Have blade replaced by
The blade and excentric drive are consumables and are not included in the
GARDENA Service.
guarantee.
Value Value
EasyCut 450/50 EasyCut 500/55
(Art. 9831) (Art. 9832)
450 500
230 / 50 230 / 50
3,800 3,800
50 55
18 18
2.8 2.8
Unit Value
EasyCut 420/45
(Art. 9830)
84
1)
dB (A)
PA
3
PA
2)
WA
94 / 97
dB (A)
2.04
WA
3.8
1)
m/s
2
vhw
1.5
a
EN 60745-2-15
1)
NOTE: The stated vibration emission value has been measured according to
a standardized test procedure and can be used for comparison of one electric
power tool with another. It can also be used for preliminary evaluation of expo-
sure. The vibration emission value can vary during actual use of the electric power tool.
Extends the life of the blade.
Easy and comfortable collecting of the chopped
property.
mendations in the operating instructions.
product.
If problems arise with this product, please contact our Service depart-
ment. In the event of a warranty claim, please send the defective product
together with a copy of the purchase receipt and a description of the
defect, sufficiently stamped, to the GARDENA service address on the
back page.
Value Value
EasyCut 450/50 EasyCut 500/55
(Art. 9831) (Art. 9832)
84 84
3 3
94 /97 94 / 97
2.04 2.04 dB (A)
3.8 3.0
1.5 1.5
RL 2000/14/EC amended by 2005/88/EC
2)
Art. 2366
Art. 6001
9