Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
•
When wearing gloves and operating models with in side
trigger, always be sure that the gloves will not pre vent
the trigger from being released.
•
Wear safety shoes, hard hat, safety goggles, gloves,
dust mask and any other appropriate pro tec tive clothing
while operating the tool.
•
Do not indulge in horseplay. Distraction can cause ac ci-
dents.
•
Keep hands and fingers away from the throt tle lever
until it is time to operate the tool.
•
Never rest the tool or chisel on your foot.
•
Never point the tool at anyone.
•
Compressed air is dangerous. Never point an air hose
at yourself or co–workers.
•
Never blow clothes free of dust with com pressed air.
•
Be sure all hose connections are tight. A loose hose not
only leaks but can come completely off the tool and while
whipping under pressure, can injure the operator and
others in the area. At tach safety cables to all hoses to
prevent injury in case a hose is accidentally broken.
•
Never disconnect a pressurised air hose. Al ways turn off
the air supply and bleed the tool be fore dis con nect ing
a hose.
•
The operator must keep limbs and body clear of the
chisel. If a chisel breaks, the tool with the bro ken chisel
projecting from the tool will sud den ly surge forward.
16
All manuals and user guides at all-guides.com
WARNING LABEL IDENTIFICATION
WARNING
SPECIFIC WARNINGS
ON
OFF
•
Do not ride the tool with one leg over the han dle. In ju ry
can result if the chisel breaks while riding the tool.
•
Know what is underneath the material being worked.
Be alert for hidden water, gas, sewer, tele phone or elec-
tric lines.
•
Use only proper cleaning solvents to clean parts. Use
only cleaning solvents which meet cur rent safety and
health standards. Use cleaning sol vents in a well-ven-
ti lat ed area.
•
Do not flush the tool or clean any parts with die sel fuel.
Diesel fuel residue will ignite in the tool when the tool
is operated, causing damage to in ter nal parts. When us-
ing models with outside triggers or throttle levers, take
care when set ting the tool down to prevent ac ci den tal
op er a tion.
•
Do not operate the tool with broken or dam aged
parts.
•
Never start the tool when it is lying on the ground.
•
This tool is not designed for working in ex plo sive at mo-
spheres.
•
This tool is not insulated against elec tric shock.
Werbung
Inhaltsverzeichnis
