System Reset - Victron energy Blue Smart IP22 Charger 12/15 Anleitung

During this procedure:
i. Bluetooth is re-enabled
ii. The PIN code is rest to default (000000)
iii. Any active Bluetooth connections are disconnected
iv. All Bluetooth pairing information is cleared
Subsequently, before attempting to re-connect it's also necessary to remove/clear the Blue
Smart Charger Bluetooth pairing information from any devices (mobile phones or tablets) that
were previously paired.

4.4 System reset

It is possible to perform a full system reset to restore all charger/battery related settings to their
default value; using the VictronConnect app.
Note that this does not reset any Bluetooth related settings, such as the PIN code or pairing
information.
To perform a system reset:
i. Access the 'device options' by selecting the 'settings' icon (gear) in the top right corner, then the
'device options' icon (three vertical dots).
ii.
Open the 'restore device' page by selecting 'Reset to defaults'.
iii. Select 'YES' to reset all settings to factory defaults.
16