NOCO Genius G26000EU Bedienungsanleitung Seite 6

16V AGM charge mode is for 16V AGM batteries only. 16-volt AGM batteries are commonly found in racing vehicles, where the alternator might
be removed, or used to improve the performance of the injector or fuel pump. CAUTION. USE THIS MODE WITH CARE. THIS MODE IS FOR
16-VOLT AGM BATTERIES ONLY. DO NOT USE ON A 12-VOLT BATTERY. CONSULT THE BATTERY MANUFACTURER BEFORE CHARGING
AND ASK FOR RECOMMENDED CHARGING RATES AND VOLTAGES.
Using 13.6V Supply. [Press & Hold]
13.6V Supply converts the charger to a constant current, constant voltage DC power supply. It can be used to power 12VDC devices, including;
tire inflators, oil changers, coffee pots, seat heaters and more. As a power supply, it can also be used to retain a vehicle's on-board computer
settings during battery repair or replacement. 13.6V Supply provides 13.6-volts at 5A with overload protection at 6A (Max). CAUTION. THIS
MODE IS FOR 12-VOLT LEAD-ACID BATTERIES ONLY. PRIOR TO USE, READ YOUR12VDC DEVICE MANUAL TO DETERMINE IF IT IS
SUITABLE FOR USE WITH THIS MODE. BOTH THE SPARK PROOF AND REVERSE POLARITY SAFETY FEATURES ARE DISABLED IN THIS
MODE. DO NOT ALLOW THE POSITIVE AND NEGATIVE BATTERY CLAMP OR EYELET TERMINAL CONNECTORS TO TOUCH OR CONNECT
TO EACH OTHER AS THE CHARGER COULD GENERATE SPARKS. CHECK THE POLARITY OF THE BATTERY TERMINALS BEFORE USING
THIS MODE.
JumpCharge.
JumpCharge is a feature for jumpstarting low-voltage or dead vehicle batteries. JumpCharge uses precision charge control to avoid overloading
the battery that shortens the life of your battery. To operate JumpCharge, the charger must be connected to a 12-volt battery with the Battery
Clamp Connectors connected. Press the JumpCharge button to begin jumpstarting your vehicle. Once initiated, the Charge LEDs will begin
showing the progress of the JumpCharge from 25% to 100%. When using this mode, the Charge LEDs do not display the battery's state-
of-charge (SOC), only the JumpCharge progress. CAUTION. USE THIS MODE WITH CARE. THIS MODE IS FOR 12-VOLT LEAD-ACID
BATTERIES ONLY. DO NOT USE JUMPCHARGE MORE THAN TWO (2) TIMES WITHIN A TWENTY-HOUR (24) HOUR PERIOD. IF TWO (2)
JUMPCHARGES CANNOT SUCCESSFULLY START YOUR VEHICLE, HAVE YOUR BATTERY EVALUATED BY A PROFESSIONAL.
Jump
Delivers 20A for five (5) minutes to jumpstart your dead vehicle battery. When selected, a white LED will illuminate.
(Red Manual Mode)
CHARGE
5Min | 20A | Up to 500Ah Batteries
Connecting to the Battery.
Do not connect the AC cable until the connection of the battery is made first. Do not make any connections to the carburetor, fuel lines, or thin
sheet metal parts. The below instructions are for a negative ground system. If a positive ground system (very uncommon), follow the below
instructions in reverse order.
1.) Connect the positive (red) battery connector to the positive (POS,P,+) battery terminal.
2.) Connect the negative (black) battery connector to the negative (NEG,N,-) battery terminal or vehicle chassis.