Zipro Shox RS Bedienungsanleitung Seite 19

EN
CAUTION! Be careful during the assembly and do not let children near the assembly area. They
may ingest small parts used during the assembly (nuts, bolts, etc.).
OPERATION
Make sure the device has been assembled correctly before starting the training.
 Before your first training, get familiar with all the functions and adjustments available for
the device.
 Some parts of the device may corrode. It is, therefore, inadvisable to leave the device in a
room with a high moisture content. Take care not to allow the device (in particular internal
and electronic components) to be exposed to water, beverages, sweat, etc.
 The device is intended for adult training and is NOT a toy. If you allow children to use it at
your own discretion, you must provide them with instructions of appropriate use and
ensure constant supervision.
 This is not a therapeutic device.
 Slight humming noise may be heard during operation due to the inertial movement of the
flywheel caused by the structure. It does not affect the operation of the device. Any
possible humming noises heard when rotating the pedals backwards occur for technical
reasons and have no negative consequences.
 Before each training, make sure the protective devices are operational and bolt and plug
connections are tight.

Wear appropriate (sports) shoes during the training.
ASSEMBLY
The device must be assembled carefully by an adult. In case of doubt, ask a more experienced
person for help.

Prior to the assembly, make sure the set contains all the listed elements and whether none
of the parts was damaged during transport. If any parts are missing or you have any other
reservations, contact the seller.
 Have a look at the drawings and explanations and follow the assembly manual when
assembling the device.

Be careful during the assembly. There is a risk of injury when using the tools and parts.
 Remember to keep your surroundings safe. Do not let tools and parts lie around in chaos.
Remember that plastic foil and bags pose o suffocation risk to small children.
 Assembly parts necessary for a specific step in the assembly manual are shown in pictures
and included in instructions. Use the elements indicated in the assembly manual.
 Do not tighten parts completely during the first stages of the assembly. Tighten
connections after all parts are placed and fitted properly.
 The manufacturer may have assembled some parts.
CAUTION! Use of spare parts other than those produced by the manufacturer voids the warranty.
Parts from other suppliers may be used for repairs after the warranty period.
19