Axis Q60 Series Installationsanleitung Seite 22

Page 22
Unit Connectors
Network connector – RJ-45 Ethernet connector. Supports Power over Ethernet Plus (PoE+), see
table below. Use AXIS T8123 High PoE Midspan 1-port (included).
Product
AXIS Q6032
AXIS Q6034
AXIS Q6035
Note:
Always use a shielded network cable (STP) between the camera and the end point and
ensure that the end point is properly grounded. Installations of Axis cameras using a
shielded network cable (STP) and a properly grounded end point have been tested to comply
with industry immunity standards' levels such as surge protection. Any other installation
method will void the warranty and leave the unit at a risk.
Multi-connector – Terminal connector for connection of external equipment:
• Audio equipment
• Input/output (I/O) devices
• AC/DC power supply
When connecting external equipment to the network camera, a multi-connector cable is required in
order to maintain the IP52 rating. The multi-connector cable can be purchased from your Axis
reseller. For more information, please see the User Manual available from the AXIS Network Video
Product CD supplied with this product or from the website at www.axis.com
SDHC card slot – A standard or high capacity SD card (not included) is required to store images
locally in the network camera. To insert and remove the SD card, the dome ring and the dome cover
must be removed, see
Note:
Before removal, the SD card should be unmounted to prevent corruption of recordings. To
unmount the SD card, go to Setup > System Options > Storage > SD Card and click
Unmount. For more information, please see the User Manual available from the
AXIS Network Video Product CD supplied with this product or from the website at
www.axis.com
Maximum power consumption PoE (IEEE802.3at)
21 W
21 W
23 W
Install an SD card (optional),
AXIS Q6032/Q6034/Q6035 Installation Guide
on page 8.