Mounting; Exposed Type - Panasonic CZ-RTC3 Installationsanleitung

Mounting

1
Remove the bottom case.
2
Mount to the wall.
Preparation: Make 2 holes for screws using a driver.
3
Mount the top case.
Align the claws of the top
case and then align the
claws of the bottom case.
2
Connect the remote control
wiring
Arrange the wires along the groove
of the case.
8
(EN)
Insert the
driver and
slightly turn.
Flat-blade
screwdriver
Bottom
case

Exposed type

Cut here with a
nipper and remove
the burr with a fi le.
Claw (2 places)
Hole for screw
Wood screw
(supplied)
Attention
Mounting the bottom case
Tighten the screws securely until
the screw heads touch the bottom
case.
(Otherwise, loose screw heads may
hit the PCB and cause malfunction
when mounting the top case.)
Do not over-tighten the screws.
(The bottom case may be deformed,
resulting in fall of the unit.)
Connecting the remote control wiring
Arrange the wires as shown in the illustration for  in
step 2, avoiding unnecessary wires being stored in the
remote controller case.
(Caught wires may destroy the PCB.)
Avoid wires touching parts on the PCB.
(Caught wires may destroy the PCB.)
1
Mount the bottom case to the wall.
Wall to which
the remote
controller is
fi xed
Claw (2 places)
Top case
Bottom case (Back side)
(Back side)
Clamper
(supplied)
Pass through
the hole
Remote controller terminal board
Remove the coating. Approx. 6 mm
Remove the sheath. Approx. 180 mm
Make sure the wiring connection
is in the correct direction.