Replacing The Lamp; Closing The Door - Electrolux IK2581BNR Benutzerinformation

All manuals and user guides at all-guides.com
Problem
Water flows on the floor.
Temperature cannot be
set.
dEMo appears on the dis‐
play.
The temperature in the ap‐
pliance is too low/too high.
If the advice does not lead to
the desired result, contact
the nearest Authorised
Service Centre.

8.2 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Possible cause
The water outlet is clog‐
ged.
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The "FastFreeze func‐
tion" or "FastCool func‐
tion" is switched on.
The appliance is in dem‐
onstration mode.
The temperature regula‐
tor is not set correctly.
The door is not closed
correctly.
The food products' tem‐
perature is too high.
Many food products are
stored at the same time.
The door has been
opened often.
The "FastFreeze func‐
tion" or "FastCool func‐
tion" is switched on.
There is no cold air circu‐
lation in the appliance.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.

8.3 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to assembly instructions.
ENGLISH
Solution
Clean the water outlet.
Attach the melting water out‐
let to the evaporative tray.
Switch off "FastFreeze func‐
tion" or "FastCool function"
manually, or wait until the
function resets automatically
to set the temperature. Refer
to "FastFreeze function" or
"FastCool function".
Keep the OK pressed for ap‐
proximately 10 seconds until
a long sound is heard and
display shuts off for a short
time.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before storage.
Add less food products at
the same time.
Open the door only if neces‐
sary.
Refer to "FastFreeze func‐
tion" or "FastCool function".
Make sure that there is cold
air circulation in the appli‐
ance.
17