Cleaning And Maintenance; Warranty & Service; Replacing The Lamps; Error Codes - Sunshower COMBI Handbuch

CLEANING AND MAINTENANCE

The outside of the Sunshower is the only part that may be cleaned by the user.
• The Sunshower can only be cleaned by hand.
• Never use a high-pressure spraying pistol to clean the Sunshower.
• Do not clean the Sunshower when the unit is on.
Only use mild cleaning products for the Sunshower. Glass cleaner or "general
cleaner" can damage the glass and make it dull. A special cleaning set for the
Sunshower is available. The set contains a mild cleaner and a protector, which
protects the Sunshower from limescale formation. For additional information
email info@sunshower.nl.

REPLACING THE LAMPS

The UV output of the UV lamps reduces over time. The lifespan of the Philips
HPA Cleo Swift 250-500 is 750 hours. After 600 hours of operation the operation
panel displays a code (see page 12). This means that the capacity of the lamps
has reduced to a level at which replacement is advised. This occurs after four
years when the average use of the Sunshower is three times per week. You can
continue to use the Sunshower if you choose not to replace the lamps, yet their
effectiveness is reduced.
Allow the lamps (Philips HPA Cleo Swift 250-500) to be replaced by Sunshower.
PLEASE NOTE: if other lamps or glass panes are used, this affects the UV
radiation. It is not permitted to replace the lamps yourself. The warranty is
voided if the Sunshower is opened.
The IR lamps (500 W) have a long lifespan of 2000 hours and they remain
effective. They only need to be replaced if they cease functioning completely.
WARRANTY & SERVICE
The Sunshower Combi has a 2 year warranty. A correctly carried out installation
in combination with your purchase receipt gives the right to warranty. The UV
lamps are not covered by the terms and conditions of the international warranty.
Sunshower is only responsible for product and design malfunctions. Sunshower
cannot be held liable for the consequences as a result of careless use of this
product or for the consequences caused by the violation of local regulations. If
the Sunshower is damaged as a result of neglecting the user manual, the right
of warranty is voided. We are not liable for material damage or personal injury
caused by the incorrect use or by neglecting the safety instructions. In such
cases the warranty becomes void.

ERROR CODES

The operation panel can display 2 error codes:
1. Temperature/ glass seal error code
(A beep sounds for 10 sec + LED lamps flash quickly for 10 sec). The glass pane
is not closed properly, is broken, removed or the Sunshower has overheated.
PLEASE NOTE: The Sunshower is no longer waterproof if the glass pane
is missing! Switch off the Sunshower completely by switching off the relevant
ground fault circuit breaker in the meter box and contact your supplier or
Sunshower directly: www.sunshower.nl.
2. Replacing UV lamps
(At the start of the UV session 5 LED's flash alternatively). This occurs after
600 hours of operation, this means that the capacity of the lights has reduced
and it is recommended to replace these. You can continue to make use of the
Sunshower by pressing the UV button once more. Also refer to REPLACING THE
LAMPS .
USER MANUAL COMBI | P1011 REV F
7