Zanussi ZCAN26EW1 Benutzerinformation Seite 34

10. Set the temperature to MAX setting and close
the lid. Wait two or three hours before you
reload previously removed food into the
appliance.
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
WHAT TO DO IF...
There are sounds which may occur during the operation of the appliance (e.g. bubbling,
whirring, cracking or clicking), which are normal.
Problem
The appliance does not oper-
ate.
The appliance is noisy.
Temperature indicator flashes
from left to right.
The lid does not close com-
pletely.
The lid is difficult to open.
The lamp does not work.
The compressor operates con-
tinually.
34
11. Set the temperature to the desired setting.
Possible cause
The appliance is switched off.
The mains plug is not connec-
ted to the mains socket cor-
rectly.
There is no voltage in the
mains socket.
The appliance is not supported
properly.
The appliance touches the wall
or other objects.
Temperature sensor error.
Food packages are blocking
the lid.
There is too much frost in the
appliance.
The lid gasket is dirty or sticky.
The lamp is defective.
Temperature is set incorrectly.
Solution
Switch on the appliance.
Check if the appliance is plug-
ged correctly.
Connect the appliance to a
different electrical mains sock-
et. Contact a qualified electri-
cian.
Check if the appliance stands
stable. Refer to "Installation/
Location" chapter.
Slightly move the appliance.
Refer to "Installation/Location"
chapter.
Contact the Authorised Serv-
ice Center.
Arrange the packages in the
right way.
Defrost the appliance. Refer to
"Care and cleaning/Defrosting
the appliance" chapter.
Clean the lid gasket.
Contact the Authorised Serv-
ice Center to replace the LED
light.
Refer to "Control panel/
Temperature regulation" chap-
ter.