Operation - Blumfeldt Andora Handbuch

EN
24

OPERATION

Lighting:
The heater can be regulated to three different heat intensities
Pos.1,Pos.2,Pos.3.
• Press down and turn the control knob to and hold for 10 seconds.
• Whilst still pressing down the control knob press the ignition button until
the pilot light (at the bottom of the burner) ignites. Continue to hold the
control knob down for 10-15 seconds more. Release the button if the
pilot flame goes out repeat the above operation
Heat settings
To change from minimum to maximum gently press control button and turn it
position 3. To change from maximum to medium gently press control button
and turn it position 2.
Turn off heater at cylinder or turn the switch on the regulator to the "OFF"
position. If the heater is not be used for a period of time disconnect the
regulator from the cylinder and replace any value protection plug or cover
Attention!
Do not forcefully turn the control knob, the button must be pushed down
before changing the heat control settings. The control button will not turn
without pushing downwards. Ensure the button is locked into the heat
setting /position required.