Advanced Options; Manual Control - Motion CM-07 Handbuch

Advanced options

16

Manual control

In case there is no remote control or pull control, the blind can
be operated with the program button on the motor.
Hold the program button to manually operate
16.1
the blind. The blind will move as long as the
button is being pressed. (max. 15 sec.)
To move the blind in the opposite direction,
16.2
release the program button and repeat step
16.1.
17 Single select 5 channel remote
Single select makes it possible to activate program mode on a single blind through a
remote control, without having to physically press the program button on the blind.
To activate
17.1
Single select,
simultaneously
hold the centre
button and press
the pair button.
Once a blind is found,
17.3
the channel LED will
flash and the blind starts
stepping, indicating that
program mode has been
activated. The blind
can now be (un)paired
to the remote and/or
programmed.
M OT I ON C M - 0 7 DC M I D M O TO R
17.2
+
To search for
17.4
the next blind,
press the right
button. Search
mode will be
activated.
To find the
previous blind,
press the left
button.
The remote starts searching
for blinds (search mode).
This is indicated by the LEDs
flashing from left to right.
To exit
17.5
Single select,
press the
right button
during
search
mode.