Quick Start - NEC MultiSync Advanced serie Bedienungsanleitung

Quick Start

To attach the MultiSync
these instructions:
1. Turn off the power to your computer.
2. If necessary, install the display card into your system. For more information,
3. For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to the
For the Mac: Connect the MultiSync A
NOTE: To obtain the MultiSync A
4. For download information on the Windows
5. Connect one end of the power cord to the MultiSync A Series monitor and the
6. Turn on the monitor (Figure D.1) and the computer.
NOTE: If you have any problems, please refer to the Troubleshooting section of
78134441.wpc
Downloaded from www.Manualslib.com
refer to the display card manual.
connector of the display card in your system (Figure A.1). Tighten all screws.
cable adapter (not included) to the monitor connector on the Macintosh
(Figure B.1). Attach the 15-pin mini D-SUB end of the captive signal cable to
the MultiSync A + or MultiSync A
500
computer (Figure B.1). Tighten all screws.
NEC Technologies at (800) 820-1230.
MultiSync monitor, refer to the References section of this User's Manual.
other end to the power outlet (Figure C.1).
this User's Manual.
manuals search engine
A Series monitor to your system, follow
®
+ or MultiSync A
™
500
+ Macintosh cable adapter on the
700
+ or A + Macintosh cable adapter, call
500 700
95/98 INF file for your
®
Captive Signal Cable
15-pin mini D-SUB
Figure A.1
3
5
+ Macintosh
™
700
11/20/98, 12:33 PM