Zipro Drift Bedienungsanleitung Seite 24

6. Install the computer
Connect the heart rate measurement cable (24)
and the connecting cable (18) from the top of
the handlebar post to computer cables (8) and then
install the computer (8) on the handlebar post (4)
using bolts (30).
Congratulations! You have assembled magnetic bike!
Read the manual carefully before using the bicycle.
ADJUSTMENTS
Resistance adjustment
In order to increase the resistance, turn the resistance knob clockwise. In order to decrease the resistance,
turn the resistance knob counterclockwise.
Saddle height
Loosen the adjustment knob. Set the saddle at the right height and tighten the knob. Make sure the saddle is
secured.
Adjusting pedal straps
Fix the side of the rubber strap with three holes to the internal part of the pedal. Fix the other end to one of
the adjustment opening so that the feet is fixed during training and easy to take out. Repeat for the other
pedal.
MAINTENANCE
Carry out maintenance activities at regular intervals. The tasks listed below should be carried out at least
every 20 hours of operation.
•
Check moving parts of the device. If they need lubrication, use a bicycle bearing grease.
• Check the conditions of such parts as bolts and nuts. Make sure they are tight.
•
Wipe the sweat off the device after each training. Make sure the display does not come in contact
with water or moisture.
• Clean the product with soapy water only. Do not use cleaning agents.
•
Store the device in a dry and warm place.
• Do not expose the device to direct sunlight.
EN
24