Zipro Shox RS Bedienungsanleitung Seite 23

EN
3. Install arms and pedals
3a. Fix the left handle arm (6L) to the handlebar
column (2) with hexagonal bolts (24), spring
washers (52), washers (64), flat washers
(25)(54), handle arm sleeve axle (26)
and the long axle (27).
Do not tighten all the elements yet.
3b. Fix the left pedal base (5L) to the crank (22)
with the left pedal base pin (38L), washers
(62), spring washers (41), and the left nylon
nut (42L).
Do not tighten all the elements yet.
NOTE! Screw the left pedal base pin
(38L) counterclockwise. Screw the
right pedal base pin (38P) on
clockwise.
3c. Fix the left handle arm (6L) to the left pedal
base (5L) with hexagonal bolts (30), flat
washers (31) and the nut (32). Put nuts
(23)(57) on the upper and lower part of the
handle arm and nuts (43) on the rear part of
the left pedal base (5L) to cover the fixing
bolts.
3d. Repeat steps 3a, 3b, and 3c for the right
handle arm (6R) and right pedal base (5R).
3e. Fix the left and right pedal (10L/R) to the
pedal base (5L/R) with hexagonal bolts (33),
flat washers (34), and nuts (35).
NOTE! The right pedal base is marked 'R'
and the left pedal base is marked 'L'
3f. Tighten all elements.
4. Install the handlebar
Run the heart rate measurement cable (50)
through the handlebar column (2) and through
the computer bracket opening.
Fix the handlebar (8) to the front column (2)
using hexagonal bolts (51), flat washers (31)
and spring washers (52). Fix the handlebar
cover (53).
Screw the left and right handle (7L/R) to the left
and right handle arm (6L/R) with bolts (45),
curved washers (44) and nuts (58).
23