Zipro Shox RS Bedienungsanleitung Seite 22

EN
ASSEMBLY MANUAL
CAUTION! Follow the steps below during the assembly and use tools supplied with the product.
Prepare sufficient space for the assembly operation.
It is advisable to assemble the product with another person because of the weight of some elements.
1. Install the front and rear base
Fix the rear (4) and front base (3)
to the main frame (1) using bolts (12), curved
washers (13), and nuts M8 (14).
ATTENTION! Remove any plastic
or cardboard safety inserts before assembly.
2. Install the cables and front column.
Connect the connecting cable (18) to the
computer cable (20).
Next, connect the resistance adjustment cable
(19) to the other connecting cable (18) as
shown in the picture.
Slide the nut of the upper resistance
17
adjustment cable (17) into the slot in the
18
bracket of the lower resistance adjustment
cable (19), pull and tighten the upper cable (17)
and move the lower cable bracket (19)
vertically. Cable nut should be on the bracket
as shown in the picture.
Fix the front column (2) to the main frame (1)
20 19
with Allen bolts (16) and washers (56).
22