Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled with the
master unit without the need for a DMX controller. The devices must be set to the corresponding operating modes.
1
Configure all slave units before connecting the master unit by setting the DMX start address in menu d to 1.
2
Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the DMX
output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been connected in
a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller to the DMX input of
the master unit.
3
Set the master unit to the desired operating mode (color mode or effect program). The interconnected devices
will now operate in sync.
Setting the DMX start address
To be able to operate the device with a DMX controller, the DMX start address must be set for the first DMX
channel. The start address depends upon which DMX controller is being used. Please refer to the controller's
documentation. Press the MENU button so many times until mode d is indicated in the display. Then use the
buttons UP and DOWN to set the address. You can now control the spotlight with your controller. A dot will flash
when DMX signals are being received. If no control signals are available, the dot will not flash.
Note: Please make sure that you do not have any overlapping channels in order to control each device correctly
and independently from any other fixture on the DMX chain. If several devices are addressed similarly, they will
work synchronically.
Functions in DMX mode
Channel
Value
1
000 – 255
2
000 – 255
3
000 – 255
4
000 – 255
5
000 – 255
000 – 000
6
001 – 010
011 – 255
MASTER/SLAVE OPERATION
DMX OPERATION
Brightness red (0 – 100%)
Brightness green (0 – 100%)
Brightness blue (0 – 100%)
Brightness white (0 – 100%)
Total Brightness (0 – 100%)
No function
Sound control
Strobe with increasing speed
22 • EN
Function