Cautions For Use - Num'axes Canicalm Small Gebrauchsanleitung

How to check that your product is functioning properly
●
You can check that your collar is functioning properly at any time using the following
procedure:
− Before doing so, make sure that the receiver collar is turned « off ».
− Place the neon test lamp in contact with each of the contact points (by unscrewing them
then by screwing them up in order to grip wires of the lamp under the contact points).
− Turn « on » the collar.
− Rub the bark detection contact point on a rough surface to check the correct trigger of
the collar (See Diagram 1).
− The collar should emit beep sounds and the test lamp should light (on operating mode
Nr 1, the test lamp will not light - mode Nr 1 is the «beep sound only» mode).
− Before disconnecting the test lamp, make sure the collar is turned « off » (indicator
light off).

Cautions for use

●
− The device is showerproof only: it is only designed to remain a short time in the rain.
− The dog should not wear any medal, metallic collar, or any other kind of collar together
with the device.
− Do not place or keep the collar in places exposed to high temperatures.
− A charge/discharge cycle is recommended once a month.
Maintenance
●
Avoid cleaning the product with volatile liquids such as solvents or cleaning fluids. Use a
soft cloth slightly moistened with a neutral detergent. The strap can be hand-washed with
soapy water.
Troubleshooting
●
Should your product stop working or develop a fault, first read this guide over, and then
make sure that the problem is not caused by a weak battery or incorrect settings. Also
check that you are using the product correctly.
Gb - 21