Changing Operating Modes - Num'axes Canicalm Small Gebrauchsanleitung

Inhibition of any further stimulation is dependant on the absence of any barking within the
next 30 seconds.
The stimulation function can be inhibited selecting operating mode Nr 1. In this case, only
beep sounds will be emitted.
After being activated 9 times in quick succession, the collar will automatically go into
safety mode for 2 minutes before restarting itself normally.

Changing operating modes

●
In the factory, the collar is set to mode Nr 2 (beep sound + progressive stimulation for
sensitive dog).
To change the collar's mode, proceed in the following way:
When switching on the collar, keep the magnetic key in contact with the
front of the collar (See Diagram 4).
After the beep sound indicating that the collar is on, a series of beep sounds together with
indicator light flashes is emitted (from 1 to 3) indicating the selected mode.
Keep the magnetic key in contact with the
Remove the magnetic key when you have reached the mode you wish.
The collar will memorize your selected mode.
Next time you will switch on the collar, your collar will be turned on to the last mode you
previously selected.
Number of beep sounds together
with indicator light flashes emitted
1
2
3
symbol to run through modes.
Mode Operation
Nr 1 Beep sounds only
Beep sound + progressive stimulation for
Nr 2
sensitive dog
Beep sound + progressive stimulation for
Nr 3
difficult dog
Gb - 19
symbol on the