Changing The Contact Points - Num'axes Canicalm Small Gebrauchsanleitung

Checking/reloading collar battery
●
5 beep sounds + indicator light flashes in red 5 times when turning on/off the collar = the
battery is too low.
When the battery is too weak, the product switches to safety mode and the system locks
up.
You must charge the battery (full charge takes approximately 2 hours - see § Charge of
the battery).

Changing the contact points

●
Two different series of contact points are supplied. The length of the contact points must
be sufficient to have proper contact with the dog's skin, enabling the device to operate
correctly (proper barking detection and correct transmission of the stimulations).
If you have a long-haired dog and the short contact points fitted to the collar in the factory
are inadequate, remove and replace them with the long ones supplied with the kit.
Carefully tighten them manually (do not use a key).
Collar adjustment
●
Collar adjustment is very important. In fact, this setting determines the proper barking
detection and the correct transmission of the stimulations.
The strap should be adjusted so that the contact points come right into contact with the
dog's skin:
− If the strap is too loose, the collar will not operate properly. Moreover, the collar is likely
to move and repeated friction can irritate your dog's skin.
− If the collar is too tight, the dog will have breathing difficulties.
The strap is properly adjusted when you can insert two fingers between the strap and
your dog's neck.
If necessary, replace the short contact points with the long ones supplied with the kit (ref.
§ Changing the contact points).
Gb - 20