Test Procedure For Solenoid - Ramsey Winch RE 50,7 Bedienungsanleitung

TEST PROCEDURE FOR SOLENOIDS
Steps to follow when testing current flow through DC
solenoids.
It should be noted that when testing a 12 volt or 24 volt
solenoid, the DC motor and battery must be of the same
voltage.
To test the solenoids: (See Figure 1).
1. Securely clamp a motor to a bench or work surface.
2. Attach a #6 gauge jumper wire from "A" terminal on the
motor to one of the field terminals on the motor, (F-2).
3. Attach the other motor field terminal (F-1) to one of the
side terminals of the solenoid.
4. Ground the solenoid to the motor with a wire as shown.
5. Attach positive (+) battery wire to the opposite side
terminal of solenoid. Ground the negative (-) battery wire
to the motor housing.
(TOP TERMINALS)
SIDE
GROUND WIRE
FROM SOLENOID
(+)
(-)
BATTERY
FIGURE 1
SIDE
(SMALL)
SOLENOID (MOTOR
HOUSING)
TO MOTOR
F2
MOTOR
Field (C)
Armature
Field (B)
Field (A)
A*
6. Touch "hot" wire, from the positive battery terminal, to
small terminal of the solenoid.
7. The motor should now be running if the solenoid is good.
If not, make sure the motor will run directly from the
battery. (See motor test procedure, Page 10).
8. To test the upper contacts use the same hookup except
use the top terminals. (See Figure 2). When hooked up
as shown in Figure 2, motor should start running.
When the "hot" wire is touched to the small terminal the motor
will stop operating.
The top terminals are normally closed; i.e. connected, and
the side terminals open, or not connected. When the solenoid
operates, the top terminals are disconnected and the side
terminals are connected.
Take care not to bring "hot" wires into contact with ground in
order to prevent electrical arcing.
F1 A
(+)
BATTERY
SOLENOID
ASSEMBLY
TO BATTERY
* See Solenoid Assembly
page 21 for connec on of A,
B, & C cable to solenoids.
TO ARMATURE
C*
B*
10
(TOP TERMINALS)
SIDE SIDE
(SMALL)
SOLENOID
GROUND WIRE
FROM SOLENOID
TO MOTOR
(-)
FIGURE 2
(MOTOR
HOUSING)
F1 A
F2