Inhaltsverzeichnis
Werbung
Boremaskinen må kun bruges med knappen til rotationsretning helt i en af
positionerne.
4. FUNKTION
Iagttag altid sikkerhedsinstruktionerne og gældende bestemmelser.
Fig. D
Hold maskinen godt fast og tryk boret i arbejdsemnet med et jævnt tryk. Der må ikke bruges
magt på maskinen.
Brug kun bor, der ikke viser tegn på slitage. Slidte bor påvirker maskinens effekt negativt.
Indstilling af omdrejningshastigheden
Maskinen kan indstilles på to omdrejningshastigheder.
•
Til langsom boring eller, når der skal skrues skruer i eller ud, indstilles knappen til
omdrejningshastighed (4) på 'lo'.
•
For hurtig boring sættes knappen på 'hi'.
Der må ikke skiftes om, mens motoren kører!
Indstilling af moment
Maskinen har forskellige momentindstillinger, så momentkraften kan justeres, når der skrues
DK
skruer i og ud.
•
Sæt ringen til momentindstilling (5) på det ønskede moment.
•
Man bør vælge den laveste indstilling, når der skrues. Vælg en højere indstilling, hvis
motoren glider.
Sådan skrues skruer i og ud
•
Sæt knappen til rotationsretning (1) i position 'R' for at skrue skruer i.
•
Sæt knappen til rotationsretning (1) i position 'L' for at skrue skruer ud.
Boring
•
Sæt ringen til momentindstilling (5) i position bor.
Sørg for, at knappen til rotationsretning (1) altid er i position 'R', når der skal bores.
Slagboring
Vælg et egnet bor til arbejdet.
94
14. If the battery pack is broken or can no longer be re-charged it must be properly disposed of.
15. Never throw the battery pack into water or a fire – it may explode.
Electrical safety
When using electric machines always observe the safety regulations applicable in your country
to reduce the risk of fire, electric shock and personal injury. Read the following safety
instructions and also the enclosed safety instructions.
Keep these instructions in a safe place!
Always check that the voltage on the batterypack corresponds to the voltage on the
rating plate. Also check that your mains voltage corresponds to the input voltage of
the battery charger.
The battery charger is double insulated in accordance with EN60335; therefore no
earth wire is required.
Replacing cables or plugs
Immediately throw away old cables or plugs when they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in the wall outlet.
3. MOUNTING ACCESSORIES
Prior to mounting an accessory always remove the battery.
Inserting and removing the drill bits
Fig. B
In addition to bits the machine can also hold screw bits with a hexagonal shaft.
•
Loosen the chuck (7) by holding one section and turning the other.
•
Position the drill bit shaft in the take up of the chuck.
•
Fasten the chuck until the drill bit is tight.
•
Open the chuck again when you want to exchange the drill bit.
Inserting and removing of the battery
Fig. C
•
Make sure that the direction switch (1) is in middle position to prevent the machine from
switching on unexpectedly.
•
Place the accumulator (3) in the bottom of the machine, as shown in the diagram, until it
engages.
•
Before removing the accumulator, depress the release buttons (A) and then take the
accumulator out from the bottom of the machine
Ferm
Ferm
UK
7
Werbung
Inhaltsverzeichnis
