Installation And Use; Safety Instructions; Use - Casselin CFP1 Benutzerhandbuch

5. INSTALLATION AND USE

5.1 Safety instructions

ELECTRICAL HAZARD
Danger from electric current!
• No contact with heat sources should take place with the power cord.
• Cord should not hang over edge of table or counter.
• Do not pour water into an appliance that is in operation or that is still hot.
• The device must be properly connected and comply with the regulations in force.
WARNING
In operation, the device can reach high temperatures. To avoid burns and accidents, do not use the device
in malfunction, and do not use spare parts that are not original.
ELECTRICAL HAZARD
Danger from electric current!
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The appliance must be unpacked
and checked completely before connection by a professional.

5.2 Use

WARNING
The set-up of the device installation and maintenance must be carried out by professionals only.
• Do not leave the appliance running without supervising it.
• During use, your hands should be dry.
• Do not move or tilt the device during operation.
MANUAL
SETTING UP
The device must be completely removed from its packaging. All protections must be completely removed.
Place the appliance upright on a solid, flat surface. Never place the appliance on a flammable surface.
Do not install this appliance near open fires, or other heating appliances.
The electrical cable should be protected to at least 16 amps. The device must be plugged directly into a wall
outlet. Using a multiple socket will cause the device to trip. The electric line must be fitted with an automatic
differential switch in accordance with the characteristics of the device, the contact opening distance must be
at least 3mm.
An efficient grounding installation is particularly recommended.
Make sure that all ventilation openings are not blocked.
Thoroughly clean all parts of the appliance before use with a suitable product. The control box must not come
into contact with water or humidity.
Make sure that the device is placed so that the user has sufficient space to operate it.
USE
Light switch :
Position 1 ► sensor function Black
Position 0 ► device off Red
Position 2 ► continuous function Light
"Touch and Go" control panel
button: time adjustment
button: off
signal: machine in operation
EN