Installation And Use; Safety Instructions; Use; Electrical Connection - Casselin CMSVC30 Benutzerhandbuch

5. INSTALLATION AND USE

5.1 Safety instructions

ELECTRICAL HAZARD
Danger from electric current!
• No contact with heat sources should take place with the power cord.
• Cord should not hang over edge of table or counter.
• Do not pour water into an appliance that is in operation or that is still hot.
• The device must be properly connected and comply with the regulations in force.
WARNING
In operation, the device can reach high temperatures. To avoid burns and accidents, do not use the device
in malfunction, and do not use spare parts that are not original.
ELECTRICAL HAZARD
Danger from electric current!
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The appliance must be unpacked
and checked completely before connection by a professional.

5.2 Use

WARNING
The set-up of the device installation and maintenance must be carried out by professionals only.
• Do not leave the appliance running without supervising it.
• During use, your hands should be dry.
• Do not move or tilt the device during operation.
INSTALLATION
The device must be completely removed from its packaging. All protections must be completely removed.
Place the appliance upright on a solid, flat surface. Never place the appliance on a flammable surface.
Do not install this appliance near open fires, or other heating appliances.
It is forbidden to place inflammable objects on the device or within 10 cm of the device.
Safety distances for flammable materials according to their degree of flammability:
Has non-flammable granite, sandstone, concrete, bricks, ceramic tiles, plaster.
B hardly flammable acumin, heraclitis, lihnos, itaver
C1 poorly flammable wood from feillus trees, plywood, hardened paper, umakart
C2 medium flammability agglomerated, solodur, cork, rubber, coatings
C3 easy flammability wood fiber boards, polystyrene, plyurethene, PVC
The electrical cable should be protected to at least 16 amps.
The device must be plugged directly into a wall outlet. Using a multiple socket will cause the device to trip.
When the appliance is placed against a wall, it must be able to withstand a temperature of 60 ° C. If this is
not the case it is essential to insert a protective layer.
Make sure that all ventilation openings are not blocked.
Thoroughly clean all parts of the appliance before use with a suitable product. The control box must not
come into contact with water or humidity.
The device can be used in ordinary environment.
Make sure that the device is placed so that the user has sufficient space to operate it.

ELECTRICAL CONNECTION

Before connecting the appliance, make sure that the nominal voltage and frequency written on the
nameplate comply with the values of the local electrical network: the maximum voltage deviation must be
plus or minus 10%.
The device must be earthed.
Position the appliance so that the plug is easily accessible in order to unplug the appliance if necessary.
EN