Playback; Audio Playback - Sony SVT-S3050P Bedienungsanleitung

Playback

1 2
SHARPNESS p STOP
1
Turn on the power of the equipment to be used.
2
Insert the cassette.
3
Select the playback speed by pressing REC/PLAY
SPEED –/+.
The selected playback speed is displayed in the
display window.
4
Press z PLAY.
Playback starts.
To stop playback
Press p STOP.
To rewind the tape
Press p STOP and then 0 REW.
To fast-forward the tape
Press p STOP and then ) FF.
To adjust the sharpness of the picture
Turn SHARPNESS to SHARP for a sharper picture or
to SOFT for a softer picture.
Resetting the tape counter
The tape counter in the display window helps you to
locate a certain scene after playback. Press COUNTER
RESET to set the counter to "0H00M00S" (counter
zero) position before playing back the tape. The VCR
keeps counting the length of the tape being played
back. Note, however, that the tape counter will not
count the portions without video signals.
Note
You cannot play back the tapes recorded on other
time-lapse VCR on this VCR and vice versa.
28
4 3
0 ) COUNTER
REW FF RESET

Audio Playback

You can play back the sound with the picture if a tape
is recorded in 3-, 12-, or 24-hour mode.
Play back the tape at the same speed at which it was
recorded so that you can monitor the sound normally.
For audio playback in 3-hour mode
Play back the tape normally.
For audio playback in 12-hour or 24-hour
mode
Press SEARCH/AUDIO ON in playback mode.
"A12" or "A24" is displayed in the display window.
To turn off the sound, press SEARCH/AUDIO ON
again.
Note
Noise appears on the screen and the sound is distorted
when you play back the picture in 12- or 24-hour
mode.
SEARCH/AUDIO ON