Disposal - Kessel EasyClean ground NS 25 Einbau Und Betriebsanleigung

6

Disposal

Carry out disposal
Remove the cover plate.
Now place the suction hose from the disposal vehicle in
the tank.
Start the pumping process at the disposal vehicle.
Wait until 1/3 of the static level has been pumped off.
How long this takes depends on the nominal size.
Cleaning the inside walls of the tank (if required)
At the same time as the pumping out process, clean the
inside walls of the tank with a water hose.
As soon as the tank has been pumped empty (slurping
noises) , end the pumping off process by the disposal
vehicle.
Wait briefly, then remove the suction hose.
Filling with cold water
Start cold water supply.
Wait until the water level has reached the static level
and then stop cold water supply.
(If there is no refill inlet available, use a water hose to fill
the tank.)
Re-insert the cover plate.
Record the disposal in the log book.
Disposal procedure is completed.
010-223
,
Installation and operating instructions 31 / 108