Philips HR7781/10 Gebrauchsanweisung Seite 8

EnglisH
8
You can also use the pusher to close the feeding tube. This prevents
ingredients from escaping through the feeding tube.
Blade unit
You can use the blade unit to chop, mix, blend or puree ingredients.
1 Put the blade unit on the drive unit on the bottom of the
bowl (Fig. 6).
The cutting edges are very sharp. Do not touch them.
2 Put the ingredients in the bowl. Pre-cut large pieces of food into
pieces of approx. 3 x 3 x 3cm (Fig. 7).
3 Put the lid on the bowl (1) and turn it clockwise to close it (2). Insert
the pusher in the feeding tube to prevent spillage (Fig. 8).
4 Press the blade unit button (Fig. 9).
tips
- When you chop onions, press the pulse button a few times to
prevent the onions from becoming too finely chopped.
- Do not let the appliance run too long when you chop (hard) cheese or
chocolate. Otherwise these ingredients become too hot, start to melt
and turn lumpy.
- Do not use the blade unit to chop very hard ingredients like coffee
beans, turmeric, nutmeg and ice cubes, as this may cause the blade to
get blunt.
- The standard processing time for all chopping jobs is 30-60 seconds.
- If food sticks to the blade or to the wall of the bowl, switch off the
appliance and unplug it. Then use a spatula to remove the food from the
blade or from the wall of the bowl.
Discs
Never process hard ingredients like ice cubes with the discs.
The cutting edges of the discs are very sharp. Do not touch them.
1 Put the tool holder on the drive unit on the bottom of the
bowl (Fig. 10).
2 Place the desired disc on top of the tool holder (Fig. 11).
Note: Place the Julienne/French fries disc on top of the tool holder in such a way
that the longer plastic part in the centre of the disc points upwards.
3 Put the lid on the bowl (1) and turn it clockwise to close it
(2) (Fig. 12).
4 Put the ingredients in the feeding tube. (Fig. 13)
- Pre-cut large ingredients into chunks that fit in the feeding tube.
- Fill the feeding tube evenly for the best results.
- When you have to process a large amount of ingredients, process small
batches and empty the bowl between batches.
5 Press speed button 1.
6 Press the pusher lightly onto the ingredients in the feeding tube.
7 When you have finished processing, press button 0.
tip
- Do not use the discs to process chocolate. Only use the blade unit for
this purpose.
Kneading accessory
You can use the kneading accessory to knead yeast dough for bread and
pizzas.
1 Put the kneading accessory on the drive unit on the bottom of the
bowl (Fig. 14).
2 Put the ingredients in the bowl (Fig. 15).
3 Put the lid onto the bowl (1) and turn it clockwise to close it (2).
Insert the pusher in the feeding tube to prevent spillage (Fig. 16).
4 Press speed button 1.
Never leave the appliance unattended when it is kneading.