Getting Started; Pairing The Camera To The Monitor - ELRO BABY MONITOR ROYALE Bedienungsanleitung

2. Digital clock: shows the time
that is set on the monitor.
3. Camera display indication.
4. Night light on/off.
5. If you are using the app on
your smartphone, this
symbol will turn white.
6. Zoom mode, indicates the
zoom factor, to 1.5 times and
2 times.
7. Monitor speaker. If the
symbol is white, the speaker
is off. If it is grey the speaker is
on.
8. Battery status:
•
Flashing: the battery is almost dead.
•
1 bar: the battery has a quarter charge.
•
2 bars of white: the battery has half a charge.
•
3 bars of white: the battery is 3 quarters charged.
•
4 bars of white: the battery is fully charged (the adapter is not connected).
•
4 bars of white and lightning bolt: the battery is fully charged (adapter is connected).
•
Lightning bolt icon: the adapter is connected.
9. Temperature display of the room in which the camera is placed.
10. Timer with alert signal for feeding times.
11. Quad screen: press this button to switch to quad screen. When two cameras are linked the
screen is split in 2 (split screen). If more than two cameras are paired, there are four different
displays shown. Up to a maximum of 4 cameras can be paired.
12. Microphone: hold this button to talk through the camera.

Getting started

1 The monitor must be fully charged by the adapter or the charging station before use. The
camera has to be powered by the adapter at all times.
2 Place the camera in a desired position. You can place the camera on a table/cabinet or mount
it to the wall using the mounting bracket.
3 Press the on/off button for approximately 4-5 seconds to turn on the monitor.
4 Slide the on/off switch to the ON position to turn on the camera.

Pairing the camera to the monitor

The monitor and camera are already paired by default. It is only necessary to pair an additional
camera. If this is the case, follow these steps:
- 6 -