Alternative Method Android; Ios Smartphone - ELRO BABY MONITOR ROYALE Bedienungsanleitung

Alternative method Android

1 Press the reset button until the night light underneath the camera flashes 3 times.
2 Then, briefly press the reset button 1 time, the night light will quickly flash.
3 Open the ELRO Babycam app and add the camera by selecting "Add Device".
4 Then scan the QR code, which you will find on the bottom of the camera.
5 Fill in "000000" at Password and press "OK".
6 Go to camera settings.
7 Press smartlink and make sure that your smartphone is connected to your 2.4GHz wifi signal.
8 Fill in the password of your wifi and press "Send"
9 The light of the camera will turn on, wait until the light turns off before you do anything.
10 The camera will now be online and the live view can be watched. You will be asked to change
the unsafe password '000000', select "OK".
11 Fill in the old and new password and select "OK". The new password should contain at least 6
characters, one uppercase letter, one lowercase letter, one digit and one special character
(choose from: ~`@#$%^*()_-+=|{}[].?/).
12 The camera is successfully added to the app!

iOS smartphone

1 Press the reset button until the night light underneath the camera flashes 3 times.
2 Then, briefly press the reset button 1 time, the night light will flash quickly. After 10 seconds
briefly press on the reset button one more time, the night light will start to flash slowly.
3 Now go to the Wi-Fi settings of your smartphone and connect to the Wi-Fi signal from the
camera, ending on - - - - - 111A with your smartphone (Comment: This network does not have
access to the internet. If you are asked to switch to a different network, choose to cancel).
4 Open the ELRO Babycam app and press "+ Add Device".
- 11 -