ELRO BABY MONITOR ROYALE Bedienungsanleitung Seite 12

5 Select "QR Code" and scan the CQ code, which you will find underneath the camera.
6 Fill in a name for your camera, enter 000000 at password and select "Save".
7 You will be asked to change the unsafe password 000000, press "OK".
8 Fill in the old password, create a new password and press "OK". The new password should
contain at least 6 characters, one uppercase letter, one lowercase letter, one digit and one
special character (choose from: ~`@#$%^*()_-+=|{}[].?/).
9 The camera will now be online and the live view can be watched.
10 Go to the camera settings
11 Press "WiFi Setting"
12 Your WiFi SSID will be filled in automatically. Enter your WiFi password. By selecting the 'eye'
symbol on the right-hand side you will be able to see what you are typing. Then, select
"Send". After selecting "Send", you will be asked to close the app. The camera will stop
transmitting the Wi-Fi signal. The night light at the bottom of the camera will stop flashing
slowly, then light continuously and flash 3 times.
13 You can now reopen the app again.
14 Swiping from left to right or up and down allows you to point the camera in the desired
position (Pan/Tilt adjustment).
Comment
If the installation has failed for some reason, start over at the beginning of this chapter. Disconnect
the camera from the power by turning the camera off and then removing the adapter from the
power outlet.
- 12 -