Electrical Connection - STEINEL professional-Serie Bedienungsanleitung

Cable length between sensor and button
< 50 m.
Package contents (Fig. 3.1, Fig. 3.4,
Fig. 3.7, Fig. 3.10)
Product dimensions (Fig. 3.2, Fig. 3.5,
Fig. 3.8, Fig. 3.11)
Product components (Fig. 3.3, Fig. 3.6,
Fig. 3.9, Fig. 3.12)
A Surface-mounting adapter
B Load module
C Connecting terminal
D Sensor module
True Presence detection zone (Fig. 3.13)
Hallway detection zone (Fig. 3.14)

4. Electrical connection

The mains supply lead is a multiple-core
cable (max. conductor Ø 2.5 mm):
L = Phase conductor (usually
black or brown)
N = Neutral conductor (usually blue)
PE = Protective-earth conductor
(usually green/yellow)
= Switched phase conductor

(usually black, brown or grey)
S = Switch
B0/B1 = Floating relay for controlling
HVAC
Important: Incorrectly wired connections
will produce a short circuit later on in the
product or fuse box. In this case, you
must identify the individual cables and
re-connect them.
Connect the mains power supply lead
COM1
(Fig. 4.1/4.4/4.7)
Connect the mains power supply lead
COM2
(Fig. 4.2/4.5/4.8)
Connecting the BT IPD mains power
supply lead
(Fig. 4.3/4.6/4.9)
5. Installation
• Check all components for damage.
• Do not use the product if it is damaged.
• Select an appropriate mounting loca-
tion, taking the reach and presence
detection into consideration.
Mounting procedure
• Switch off power supply
(Fig. 4.1/4.2/4.3)
Concealed mounting
• Connect to mains power supply.
(Fig. 5.1)
• Fit load module and screw into place.
(Fig. 5.2)
• Fit magnetic sensor module. (Fig. 5.3)
• Switch ON power supply.
Surface mounting
• Mark drill holes and drill. (Fig. 5.4)
• Screw load module into place. (Fig. 5.5)
• Connect to mains power supply.
(Fig. 5.6)
• Fit surface-mounting adapter. (Fig. 5.7)
• Fit magnetic sensor module. (Fig. 5.8)
• Switch ON power supply.
• Make settings.
(➜ "6. Function and settings")
- 18 -