About This Document; General Safety Precautions - STEINEL professional-Serie Bedienungsanleitung

GB

1. About this document

– Please read carefully and keep in a
safe place.
– Under copyright.
Reproduction either in whole or in part
only with our consent.
– Subject to change in the interest of
technical progress.
Symbols
!
Hazard warning!
Reference to other information
... in the document.

2. General safety precautions

Disconnect the power supply
!
before attempting any work
on the sensor.
• During installation, the electric power
cable being connected must not be
live. Therefore, switch off the power
first and use a voltage tester to make
sure the wiring is off-circuit.
• Installing the sensor involves work
on the mains power supply. This
work must therefore be carried out
professionally in accordance with
national wiring regulations and electri-
cal operating conditions.
• Only use genuine replacement parts.
• Repairs may only be made by spe-
cialist workshops.
• Terminal B1/B0 is a switching contact
for low-energy circuits, no more than
1 A. This must be protected by a fuse
of the appropriate rating.
3. True Presence
COM1/COM2/BT IPD
Hallway
COM1/COM2/BT IPD
Proper use
– Sensor for ceiling mounting indoors.
Sensor-switched types
– True Presence
– Hallway
The True Presence sensor is a high-
frequency sensor. It reliably identifies
human presence and absence by detect-
ing micro-movements. The detection zone
can be defined with absolute precision
via app.
The Hallway Sensor is a high-frequency
sensor with a perfect detection zone for
corridors. The detection zone can be
adjusted in both directions via app.
Interface types
COM1: relay 1
COM2: relay 1 and relay 2
(for HVAC: heating/ventilation/
air-conditioning)
BT IPD: no relay/no control
The COM1 and COM2 versions switch
loads ON and OFF. Signals are pro-
cessed and sent out.
The BT IPD version can be interconnect-
ed with other sensors via Bluetooth to
extend the detection zone. It passes on
the detected signals (presence and light
level) via Bluetooth. This is controlled
in the sensor interconnected with other
interface.
UP: concealed version
AP: surface-mounted version
- 17 -
®
GB