Control Panel - Electrolux IK3030Z Benutzerinformation

4 electrolux
Service
• Any electrical work required to do the serv-
icing of the appliance should be carried out
by a qualified electrician or competent per-
son.
• This product must be serviced by an au-
thorized Service Centre, and only genuine
spare parts must be used.
Environment Protection
This appliance does not contain gasses
which could damage the ozone layer, in

CONTROL PANEL

1. Pilot light
2. ON/OFF switch
3. Temperature regulator (warmest)
4. Temperature indicator
5. Temperature regulator (coldest)
6. Action Cool light
7. Action Cool switch
Switching on
Insert the plug into the wall socket.
Press the ON/OFF switch .
The Pilot Light will light up.
Important! At start-up the displayed
temperature don't correspond with the set
temperature until stabilised (within 24 hours).
Switching off
Press ON/OFF switch until a countdown
from -3 -2 -1 is completed.
The temperature indicator switches off. The
Pilot light switches off.
Temperature regulation
The temperature can be adjusted between
+3°C and +8°C.
By pressing the Temperature regulators, the
current temperature setting flashes on the
Temperature indicator. It is possible to mod-
ify the setting temperature only with flashed
indicator. To set a warmer temperature,
press warmest Temperature regulator. To
Fridge Control panel
ON/OFF
1 2 3 4
either its refrigerant circuit or insulation
materials. The appliance shall not be dis-
carded together with the urban refuse
and rubbish. The insulation foam con-
tains flammable gases: the appliance
shall be disposed according to the ap-
plicable regulations to obtain from your
local authorities. Avoid damaging the
cooling unit, especially at the rear near
the heat exchanger. The materials used
on this appliance marked by the symbol
are recyclable.
5 6 7
set a colder temperature, press coldest Tem-
perature regulator. The Temperature indica-
tor displays the newly selected temperature
for a few seconds and then shows again the
inside compartment temperature.
The newly selected-temperature must be
reached after 24 hours.
Temperature indicator
During normal functioning the Temperature
indicator shows the temperature inside the
fridge.
Important! Difference between the
temperature displayed and temperature
setting is normal. Especially when:
• a new setting has recently been selected.
• the door has been left open for a long time.
• warm food has been placed in the com-
partment.
Action Cool function
The maximum performance is obtained by
setting the Action Coolfunction. It's recom-
mended when loading large quantities of
food.
You can activate the Action Cool function by
pressing the Action Cool switch.
The Action Cool light will light up.