DeWalt DWS520 Anleitung Seite 32

e n gli s h
4. Press the lock lever (m) down and rotate the
blade until the lock position is found.
NoTE: The blade (k) is now locked and cannot be
turned by hand.
5. Turn the blade clamping screw (n) anti-
clockwise to remove.
6. Remove the outer flange (o) and used blade (k).
Place the new blade on the inner flange (p).
7. Replace the outer flange (o) and blade clamping
screw (n). Turn the screw clockwise by hand.
NoTE: The direction of rotation of the saw blade
and the rotation of the plunge saw MUST be the
same.
8. Tighten the blade clamping screw firmly using
the Allen key.
9. Release and turn the lock lever (m) anti-
clockwise until it stops.
10. Move the plunge saw back to top position.
11. Push plunge trigger (a) forward, to lock saw
blade change.
adjusting the riving knife (fig. 3)
For the correct adjustment of the riving knife (q), refer
to the figure 3. Adjust the clearance of the riving
knife after changing the saw blade or whenever
necessary.
1. Follow Changing the Saw Blade steps 1–4.
2. Loosen the riving adjustment screw (r) with an
Allen key and set the riving knife as shown in
figure 3.
3. Tighten the riving knife screw (r).
4. Turn the lock lever (m) anti-clockwise until it
stops.
5. Move the plunge saw back to top position.
6. Push plunge trigger (a) forward, to lock saw
blade change.
Depth of cut adjustment (fig. 4)
The cutting depth can be set at 0 – 59 mm without
guide rail attached; with the guide rail attached:
0 – 55 mm.
1. Loosen the depth adjustment knob (f) and move
the pointer to obtain the correct depth of cut.
2. Tighten the depth adjustment knob (f).
NoTE: For optimal results, allow the saw blade to
protrude from the workpiece by about 3 mm (fig. 4).
30
oPEraTion
WARnInG: Before using the plunge
saw, ALWAYS make sure all functions
are working properly!
instructions for use
WARnInG: Always observe the safety
instructions and applicable regulations.
Switching on and off (fig. 1)
Press the on/off switch to turn the plunge saw on.
holding and guiding the tool
(fig. 5, 6)
WARnInG:
• A LWAyS secure the workpiece in
such a manner that it cannot move
while sawing.
• A LWAyS push the machine forwards.
nEVER pull the machine backwards
towards you.
• A LWAyS use the plunge saw with
both hands. Put one hand on the
main handle (c) and the second hand
on the front handle (h) as shown in
figure 5.
• A LWAyS use the clamp to hold the
rail to the workpiece as shown in
figure 6.
• M ake sure the cord is not in the path
of the saw.
• Hold the tool by the main handle (c) and the
front handle (h) to guide the saw properly.
• The cutting indicator (t) displays the cutting line
for 0° and 47° cuts (without guide rail).
• The blade position indicator (y) shows the blade
position for full plunge.
• For optimum results, clamp the workpiece
bottom up.
cuTTinG
1. Place the machine with the front part of the saw
base on the workpiece.
2. Press the on/off switch to turn the saw on.
3. Push the plunge switch (a) forward, press the
saw down to set cutting depth and push it
forward into cutting direction.