Lfe Attenuator Setting; Center Speaker Distance Setting - Pioneer VSX-C550 Bedienungsanleitung

SUBWF 100 Hz
Sends bass frequencies below 100 Hz to the
subwoofer.
SUBWF PLS
Adds extra bass to the soundtrack.
SUBWF – – –
Select if you didn't connect a subwoofer.
Press SETUP to advance to the next receiver setting
mode.
Press if you want to exit the setting
ENTER
mode.
• The Subwoofer setting will appear automatically,
depending on whether you have connected a
subwoofer or not.
• The default setting is "200 Hz".
• You can only select PLS when the front speakers are
set to Large ( ).
L
• If the all the speakers are set to Large (
only select 100 kHz, PLS or off (– – –) for the
Subwoofer.
• Setting the front speakers to Small (
will use a subwoofer, thus its setting cannot be
turned off. In this case make sure you set the
subwoofer and choose its cutoff frequency.
• There are some cases where no sound will come from
the subwoofer even if it is (this depends on the
speaker setting, the listening mode and/or the kind of
source material).

LFE attenuator setting

Dolby Digital and DTS audio sources include ultra-low
bass tones. Set the LFE attenuator as needed to prevent
the ultra-low bass tones from distorting the sound from
all the active speakers.
Follow steps 1&2 on page 27 (if necessary).
Use the buttons to choose the attenuation
+/–
level 0 dB, 10 dB or LFE OFF .
0 dB
No attenuation.
10 dB
LFE volume is reduced.
LFE OFF
LFE channel is off.
Press SETUP to advance to the next receiver setting
mode.
Press if you want to exit the setting
ENTER
mode.
• The default setting is "0 dB".
Front speakers distance setting
Set the distance from the front speakers to the listening
position.
Follow steps 1&2 on page 27 (if necessary).
Use the
the front speakers from the main listening
position (within a range from 0.3 m to 9.0 m).
Press SETUP to advance to the next receiver setting mode.
Press
mode.
• The default setting is "1.8 m".
• One step equals about 0.3 m.
• If you do the Room Setup (see page 26) after the
settings here, those will take precedence.
) you can
L

Center speaker distance setting

Set the distance from the center speakers to the listening
) means you
S
position.
Follow steps 1&2 on page 27 (if necessary).
Use the
the center speaker from the main listening
position (within a range from 0.3 m to 9.0 m).
Press SETUP to advance to the next receiver setting mode.
Press
mode.
• The default setting is "1.5 m".
• One step equals about 0.3 m.
• When "
setting, the Center speaker distance cannot be set.
• If you do the Room Setup (see page 26) after making
the settings here, those will take precedence.
Fine Tuning Your Surround Sound
buttons to choose the distance of
+/–
if you want to exit the setting
ENTER
buttons to choose the distance of
+/–
if you want to exit the setting
ENTER
–" is selected in Center speaker
CENTER
29
En