Hints And Tips - Electrolux GA60GLISWE Benutzerinformation

Starting a programme
1. Keep the appliance door ajar.
2. Press the on/off button to activate the
appliance. Make sure that the
appliance is in programme selection
mode.
3. Press
programme.
• The indicator of the selected
programme flashes.
• The display shows the programme
duration.
4. Set the applicable options.
5. Close the appliance door to start the
programme.
• The programme indicator stops
flashing and comes on with fixed
light.
• The programme duration starts to
decrease with steps of 1 minute.
If you press the on/off button before the
start of the programme, the appliance will
be in programme selection mode when
you activate it again.
Starting a programme with delay
start
1. Set a programme.
2. Press Delay again and again until the
display shows the delay time you want
to set (from 1 to 24 hours).
The indicator of the selected programme
continues to flash.
3. Close the appliance door to start the
countdown.
The programme indicator stops flashing
and comes on with fixed light.
• When the countdown is completed, the
programme starts.
• While the countdown is running only
the buttons Reset and Delay are active.
It is not possible to change the
programme or options.

10. HINTS AND TIPS

10.1 Using salt, rinse aid and
detergent
• Only use salt, rinse aid and detergent
for dishwasher. Other products can
cause damage to the appliance.
or to select a
Opening the door while the
appliance operates
If you open the door while a programme is
running, the appliance stops. When you
close the door, the appliance continues
from the point of interruption.
If the door is opened for more
than 30 seconds during the
drying phase, the running
programme will end.
Cancelling the delay start while
the countdown operates
When you cancel the delay start you have
to set the programme and options again.
Press and hold Reset until the appliance
is in programme selection mode.
Cancelling the programme
Press and hold Reset until the appliance
is in programme selection mode.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
End of the programme
When the programme is completed the
display shows 0:00.
All buttons are inactive except for the
on/off button.
1. Press the on/off button or wait for the
AUTO OFF function to automatically
deactivate the appliance.
If you open the door before the activation
of AUTO OFF, the appliance is
automatically deactivated.
2. Close the water tap.
• Multi-tablets are usually suitable in
areas with a water hardness up to 21
°dH. In areas exceeding this limit, rinse
aid and salt must be used in addition to
the multi-tablets. However, in areas
with hard and very hard water we
ENGLISH 73