Bluetooth ® Pairing - Hama Voice Sport Bedienungsanleitung

completely charged.
• Once the charging process is complete, the LED
(7) is lit blue.
• Disconnect all cable and mains connections
after use.
Note
• The Bluetooth connection is not available
®
during charging.
• If the battery level is low, a voice says, 'Low
Battery'. The message is repeated twice at
5-minute intervals (approximately) before the
earphones automatically switch off. The LED
indicator (7) begins to flash red. Connect the
earphones to a suitable USB port using the
charging cable, in order to recharge the battery.
5. Operation
Switching the earphones on/off
• Press and hold the MFB button (4) for about
3 seconds until the LED (7) emits flashes of
alternating red and blue light.
• To switch off the headphones, press and hold
the MFB button (4) for about 3 seconds until the
LED (7) goes out.
Note
The functions described in this section are only
available for Bluetooth
5.1. Bluetooth pairing
®
Note – Pairing
• Make sure that your Bluetooth
terminal device is on and Bluetooth
activated.
• Make sure that your Bluetooth
terminal device is visible for other Bluetooth
devices.
• For more information, please refer to the
operating instructions of your terminal device.
• The earphones and the terminal device should be
no further than one metre apart. The shorter the
distance, the better.
• Ensure that the earphones are switched off.
• Switch on the earphones by pressing and holding
the MFB button (4) for about 3 seconds until
the LED (7) emits flashes of alternating red and
blue light. The earphones are searching for a
Bluetooth connection.
®
• Open the Bluetooth
device and wait until Hama BTH VOICE SPORT
appears in the list of Bluetooth
-capable terminal devices.
®
-capable
®
is
®
-capable
®
settings on your terminal
®
devices found.
®
• Select Hama BTH VOICE SPORT and wait until
the earphones are listed as connected in the
Bluetooth
• If the connection was successful, you will hear
another acoustic signal and the LED (7) slowly
flashes blue.
Note – Bluetooth
Some terminal devices require a password in order
to connect to another Bluetooth
• If your terminal device requests a password for
connection to the earphones, enter 0000.
Note
• After a successful connection, the LED (7)
slowly flashes blue.
• If the connection could not be set up, first
switch off the earphones and then repeat the
steps for the Bluetooth
under 5.1.
5.2. Automatic Bluetooth
successful pairing)
Note
Once the earphones have connected to a
terminal device, they will store the device and
automatically connect to it again when the device
is within range and has Bluetooth
Renewed pairing is not required for terminal
devices that have previously been connected to
these earphones.
When the earphones are switched on, they will
automatically attempt to connect to the terminal
device last connected. If you want to connect
the earphones to a new terminal device, please
follow the steps for the Bluetooth
®
listed under 5.1.
As soon as the earphones are connected to
your terminal device, music is transmitted via
Bluetooth
®
information, please also refer to the operating
instructions of your terminal device.
• Switch on the earphones with the MFB button (4).
The LED (7) begins to emit flashes of alternating
red and blue light, and the earphones automatically
connect to the terminal device last used.
Note
• If the connection was successful, the LED (7)
slowly flashes blue.
settings on your terminal device.
®
password
®
®
connection listed
®
connection (after
®
using these earphones. For further
device.
enabled.
®
connection
®
3