POWERcondens KP 50 Bedienungsanleitung Seite 33

8 Maintenance
Have maintenance and repair work carried out
by qualified specialist personnel only!
DANGER! Risk of fatal injury!
There is risk of fatal injury due to elec-
tric shocks when working on electrical
equipment. The device should be elec-
trically isolated and secured against
unauthorised switch-on before any
maintenance or repair work. Damage
to the connection cables should al-
ways be rectified by a qualified electri-
cian only.
NOTE! For safety reasons, it is not
possible to disassemble the motor unit
of the condensate lifting unit.
8.1 Cleaning the condensate coll-
ection reservoir
The inside of the condensate collection reservoir
must be cleaned regularly.
•
Remove the condensate collection reservoir
(Figure 1, item 5) by pressing in the clips and
clean with a 5% bleach base solution.
•
Check the floater for dirt and, if necessary,
clean with water or a 5% bleach base solu-
tion.
•
Remount the condensate collection reservoir.
•
Perform a functional check (Chapter 7.1).
8.2 Check the condensate drain-
age with the non-return valve
NOTE! Regularly check the non-return
valve and the seal below it for dirt and
blockages.
•
Turn the non-return valve (Figure 1, item 3)
anti-clockwise and pull it off in an upward di-
rection.
•
Check the non-return valve for dirt and clean if
necessary.
•
Check the seal for dirt and clean if necessary.
•
Place the seal in the connection of the non-
return valve.
•
Push the non-return valve down and turn it
clockwise at the same time.
EN
CAUTION! Risk of damage!
Never use aggressive cleaning agents
or sharp-edged tools, as these could
damage the seal. Use only clean water
to clean the seal of the non-return
valve.
•
Perform a functional check (Chapter 7.1).
Maintenance
6