Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6
Installation and electrical
connection
DANGER! Risk of fatal injury!
Incorrect installation and improper
electrical connections can be life-
threatening.
•
The installation and electrical con-
nection must be carried out only by
qualified personnel in accordance
with applicable regulations.
•
Observe the regulations for acci-
dent prevention.
•
Before installation and electrical
connection, disconnect the system
from the power supply and make
sure it cannot be switched on by
unauthorised persons.
•
Disconnect the mains plug!
6
Figure 1: Condensate pump KP 50
1
Condensate inlet
2
Connection for additional condensate inlet
3
Condensate discharge with non-return valve
4
Clips for opening the condensate collection reservoir (both
sides)
5
Condensate collection reservoir
6
Transport securing mechanism (both sides)
6.1
Preparations for installation
•
Select an installation location suitable for the
size of the unit and accessibility of the con-
nections.
•
Dimensions of the unit (H x W x D): 210mm x
120mm x 167mm
EN
•
The condensate lifting unit must be installed in
a dry, well-ventilated, frost-free room.
NOTE! The motor unit of the conden-
sate lifting unit can be placed either
clockwise or anti-clockwise on the
condensate lifting unit, depending on
the installation site.
•
Press in the housing clips (Figure 1, item 4)
•
Remove the motor unit.
•
If necessary, turn the motor unit, set it in place
and press down until the housing clips click
audibly.
6.2
Wall-mounted installation
WARNING! Risk of injury!
If installation is not properly carried
out there is a risk of injury and the unit
can be damaged. Have installation car-
ried out by qualified personnel only.
CAUTION! Risk of damage!
3
Position the product on the wall and
align it horizontally with a spirit level.
The product must be aligned perfectly
2
in order to function properly.
Fasten the unit to the wall with two screws
Ø4mm.
1
6.3
Installing the condensate lift-
ing unit
4
CAUTION! Danger of malfunction!
Improper inlet and discharge connec-
tions can cause the machine to mal-
5
function. The inlet and discharge hos-
es must not become trapped or kinked
after
bending radius of the hoses must not
be less than 100mm. In order to guar-
antee optimum pumping of conden-
sate, the condensate must flow unhin-
dered into the unit via the inlet hose,
and the discharge hose must always
be routed on a constantly rising gradi-
ent.
•
The 30mm diameter (Figure 1, item 1) con-
densate inlet opening is in the condensate
collection reservoir. If necessary, a second in-
let with a diameter of 19mm (Figure 1, item 2)
can be used by pressing out the perforated
seal. A hose with a diameter of 10mm is pro-
installation.
The
Installation
permissible
4
Werbung
Inhaltsverzeichnis
