Maintenance And Service; Maintenance And Cleaning - Bosch PHO 3100 Originalbetriebsanleitung

Downloaded from www.Manualslib.com
OBJ_BUCH-406-001.book Page 19 Monday, August 27, 2007 5:23 PM
– Switch on the machine.
– Apply the supporting pressure onto the front
part of the planer base plate and slowly push
the machine forward ( ). This tilts the park
rest upward ( ) so that the rear part of the
planer base plate faces on the workpiece
again.
– Guide the machine over the surface to be
planed ( ) with even feed.
Beveling Edges (see figure H)
The V-grooves in the front planer base plate allow
quick and easy beveling of workpiece edges. De-
pending on required bevel width, use the corre-
sponding V-groove. For this, place the planer
with the V-groove onto the edge of the workpiece
and guide it along the edge.
Groove to be
used
none
small
medium
large
Planing with Parallel/Beveling Guide
(see figures D–F)
Mount the parallel guide 18 or beveling guide 22
to the machine using the corresponding fasten-
ing bolt 21. Depending on the application, mount
the rebating depth stop 25 with fastening bolt 24
to the machine.
Loosen the locking nut 20 and adjust the request-
ed rebating width on the scale 19. Tighten the
locking nut 20 again.
Adjust the requested rebating depth accordingly
with the rebating depth stop 25.
Carry out the planing procedure several times un-
til the requested rebating depth is reached.
Guide the planer applying sideward supporting
pressure.
Beveling with the Beveling Guide
When beveling rebates
and surfaces, adjust the
required
with the angle adjust-
ment 23.
Bosch Power Tools
manuals search engine

Maintenance and Service

Maintenance and Cleaning

Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep
the machine and ventilation slots clean.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
In all correspondence and spare parts order,
please always include the 10-digit article number
given on the type plate of the machine.
WARNING! Important instructions for connect-
ing a new 3-pin plug to the 2-wire cable.
Dimension a
The wires in the cable are coloured according to
(mm)
the following code:
0 – 4
2 – 6
4 – 9
6 – 10
Do not connect the blue or brown wire to the
earth terminal of the plug.
Important: If for any reason the moulded plug is
removed from the cable of this power tool, it
must be disposed of safely.
Replacing the Drive Belt (see figures I–K)
Unscrew screw 7 and take off the belt cover 6.
Remove the worn drive belt 27.
Before assembling a new drive belt 27, clean
both pulleys 28 and 29.
Place the new drive belt 27 on the small pulley 29
first and then work the drive belt 27 onto the
large pulley 28 by hand while rotating it.
Reattach the belt cover 6 and tighten with the
screw 7.
slope angle
English | 19
2 609 140 473 | (27.8.07)