Set Read-Only In User Mode; Enable Read/Write In User Mode - iStorage diskAshur PRO2 Benutzerhandbuch

20. Set Read-Only in User Mode

Important: If data has just been copied to the diskAshur PRO
first by clicking 'Safely Remove Hardware/Eject' the diskAshur PRO
reconnecting and setting the diskAshur PRO
To set the diskAshur PRO
Mode (solid GREEN LED) proceed with the following steps.
1. In User mode, press and hold down "7 + 6"
buttons. (7=Read + 6=Only)
2. Release 7+6 buttons and press "UNLOCK"
Note: 1. This setting is activated the next time the drive is unlocked.
2. If a User set the drive as Read-Only, Admin can override it by setting the drive as Read/Write in
Admin mode.
3. If Admin set the drive as Read-Only, the User cannot set the drive as Read/Write

21. Enable Read/Write in User Mode

To set the diskAshur PRO
Mode (solid GREEN LED) proceed with the following steps.
1. In User mode, press and hold down "7 + 9"
buttons. (7=Read + 9=Write)
2. Release 7+9 buttons and press "UNLOCK"
Note: 1. This setting is activated the next time the drive is unlocked.
2. If a User set the drive as Read-Only, Admin can override it by setting the drive as Read/Write in
Admin mode.
3. If Admin set the drive as Read-Only, the User cannot set the drive as Read/Write
#14
to Read-Only, first enter the "User Mode" as described in section 18. Once the drive is in User
2
to Read/Write, first enter the "User Mode" as described in section 18. Once the drive is in User
2
, make sure to properly disconnect the drive
2
2
as 'Read-Only/Write-Protect'.
2
Solid
GREEN
GREEN
GREEN
as Read-Only
Solid
GREEN
GREEN
GREEN
as Read/Write
www.istorage-uk.com
from the Operating System before
GREEN LED will change to blinking
and BLUE LEDs
and BLUE LEDs will change to a solid
LED indicating the drive is configured
GREEN LED will change to blinking
and BLUE LEDs
and BLUE LEDs will change to a solid
LED indicating the drive is configured