Installing This Product; Installation Notes; Parts Supplied - Pioneer AVIC-F860BT Bedienungsanleitung

Installation

Installing this product

Installation notes

! Do not install this product in places subject
to high temperatures or humidity, such as:
— Places close to a heater, vent or air con-
ditioner.
— Places exposed to direct sunlight, such
as on top of the dashboard.
— Places that may be exposed to rain,
such as close to the door or on the vehi-
cle's floor.
! Install this product in an area strong en-
ough to bear its weight. Choose a position
where this product can be firmly installed,
and install it securely. If this product is not
securely installed, the current location of
the vehicle cannot be displayed correctly.
! Install this product horizontally on a sur-
face within 0 to 30 degrees tolerance (with-
in 5 degrees to the left or right). Improper
installation of the unit with the surface
tilted more than these tolerances increases
the potential for errors in the vehicle's loca-
tion display, and might otherwise cause re-
duced display performance.
30°
5°
! When installing, to ensure proper heat dis-
persal when using this unit, make sure you
leave ample space behind the rear panel
and wrap any loose cables so they are not
blocking the vents.
! The cords must not cover the area shown
in the figure below. This is necessary to
allow the amps and navigation mechanism
to dissipate heat.
! The semiconductor laser will be damaged
if it overheats, so don't install this product
anywhere hot — for instance, near a heater
outlet.

Parts supplied

5°
Leave ample
5 cm
space
5 cm
Do not cover this area.
This product Truss head screw
Section
03
(5 mm × 8 mm)
(6 pcs.)
21
Engb