Vertical Ironing - Zelmer Stiro ZIR3000 Benutzerhandbuch

AF-MANUAL_Plancha-ZELMER ZIR3000 stiro.pdf
EN
DRY IRONING
The steam iron can be used on the dry setting with or without water in the water tank, it is best to avoid
having the water tank full while dry ironing.
Turn the variable steam control to the minimum position.
Select the setting on the temperature control dial best suited for the fabric to be ironed.
CAUTION: If the steam iron has been used for a long time, it is hot and there is no water. Do not refill it
with water until the steam iron cools down.
SHOT OF STEAM
The shot of steam feature provides additional steam for removing stubborn wrinkles. Turn off the variable
steam control to the min position
Press the powerful steam button to release the burst of steam.
NOTE: To prevent water leakage from the soleplate, do not keep the powerful steam button in conti-
nuously and wait almost 5 seconds between pressures.

VERTICAL IRONING

By pressing the shot-steam button at intervals you can also iron vertically (curtains, hung garments, etc.)
C
NOTE: To prevent water leakage from the soleplate, do not keep the powerful steam button in conti-
nuously and wait almost 5 seconds between pressures.
M
Y
WHEN YOU FINISHED IRONING
CM
Set the temperature dial to the minimum position. Remove the main plug from the wall socket.
MY
Stand the iron on heel rest.
CY
MANITENCE AND CLEANING
CMY
It is recommended to the self-cleaning every two weeks if the water in the area is hard or semi-hard if
K
frequent use of the device is made
Before cleaning the steam iron ensure it is unplugged from the power supply and has completely cooled
down.
Do not use abrasive cleaners.
To clean exterior surfaces, use a damp soft cloth and wipe dry. Do not use any chemical solvents, as these
will damage the surface.
Cleaning the soleplate; do not use scouring pads or harsh cleaners on the soleplate as these will da- mage
the surface. To remove burnt residue, iron over a damp cloth while iron is still hot. To clean the soleplate,
simply wipe with soft damp cloth and wipe dry.
SELF-CLEANING
Fill the half of the water reservoir.
Set the temperature control to its maximum position. Insert the main plug into the wall socket.
Allow the iron to heat up until the indicator light goes out.
Unplug the steam iron.
Holding the iron horizontally over the sink and press the button of self-clean, in case if not have this button
change the steam control to the maximum position.
Boiling water and steam will be ejected from the holes in soleplate with impurities washed out Move the
12
12 12/4/21 11:38